[design]

Dfkrug,
Nice job.

Has anyone contemplated mounting a "quick hitch" cat 2 bracket to a custom sub-frame (attached at the rear axle, and the loader mounting plates.)
With the quick hitch, I think it may be possible to then use a 3 pt. hitch frame on the back hoe. The frame whould carry the top link loads to the sides into the subframe.

Picture a 4 point subframe that has the quick hitch mounted in place of the lower connecting points and a single link/bolt at the top in the center. The frame then carrys the bending loads to the outside where it can be directed to the subframe.

Still trying to design the frame for the bh-9000 and the L2900.
Design