TractorByNet.com - View Single Post

Castaway · 10-21-2007, 11:09 PM

Thanks for the reply, That was our first plan, however #3 journal would take over .40 to clear and bearings are only available up to .25. We have even looked into having it built up then cut back down. But that is no longer recomended.
We have this new engine and plan to go thru with it. Just wanted some incouragement from someone familiar with this situation.

10-21-2007, 11:09 PM	#3 (permalink)
Castaway New Member Join Date: Oct 2007 Posts: 4	Re: Yanmar Crankshaft Thanks for the reply, That was our first plan, however #3 journal would take over .40 to clear and bearings are only available up to .25. We have even looked into having it built up then cut back down. But that is no longer recomended. We have this new engine and plan to go thru with it. Just wanted some incouragement from someone familiar with this situation.