Quote:
|
Originally Posted by MtnViewRanch
I have two square tubes that go to the rear axle, each one of those have a factory bend in them, but under those tubes there is a cross brace that I have bent up. The cross brace is about in the center of the tractor between the front and rear axles. Does this make any sense?
|
I need to ask Travis if my 6520 had the two square tubes you mentioned before he installed the BH subframe. I have a wide "C" channel (just looked at it with a flashlight and it looks about 1/4 thick) cross brace bolted to the subframe right under the mid loader mount, right about half way from the rear and front axles. Right above it is the front driveshaft cover and I have a 5 inch concave dent there.
hugs, Brandi