Quote:
|
Originally Posted by MtnViewRanch
I have two square tubes that go to the rear axle, each one of those have a factory bend in them, but under those tubes there is a cross brace that I have bent up. The cross brace is about in the center of the tractor between the front and rear axles. Does this make any sense?
|
Its good to know about those braces. This highlights a problem. Those of us who bought the tractor with a BH were shorted those box tubes. If we ever decide we dont want the BH anymore we have to buy a part that should have been included with the loader. Id be interested in pics.
Brian & Brandi, On your cross brace - see if you can turn the C channel over and mount it flange up. I did this for ground clearance and ruggedness. As I recall, it took some very slight mods to the channel ends to accomplish. A worthwhile change, I think.
larry