TractorByNet.com - View Single Post - Tips on CCM top link install on 3720 cab.

nmu98 · 08-13-2008, 08:07 AM

Thanks. I have this one all set. It was simply the two banjo bolts on the toplink. I just dont want to mess with much to make it leak again.

I looked last night and I do not see the room to turn the block sideways. I could see turning it sideways and using 90's to point it up and out? But with 2 sets of 90's you could easily get the hose legnth down to 12 inches.

I might also remove the pto guard if I hit. I have not put it all the way down since the MX hits the ground before I bottom out. Its just in the way when i am trying to get stuff hooked up.

Pics of yours turned would be cool.... I could do 45, but 90 on my tractor looks tight.

08-13-2008, 08:07 AM	#9 (permalink)
nmu98 Platinum Member Join Date: Jun 2007 Posts: 891	Re: Tips on CCM top link install on 3720 cab. Thanks. I have this one all set. It was simply the two banjo bolts on the toplink. I just dont want to mess with much to make it leak again. I looked last night and I do not see the room to turn the block sideways. I could see turning it sideways and using 90's to point it up and out? But with 2 sets of 90's you could easily get the hose legnth down to 12 inches. I might also remove the pto guard if I hit. I have not put it all the way down since the MX hits the ground before I bottom out. Its just in the way when i am trying to get stuff hooked up. Pics of yours turned would be cool.... I could do 45, but 90 on my tractor looks tight.