Here is the dozer half, just removed. The
FEL brackets have very large
verticle pin spacing, compared to the Kioti pin spacing. You can see the
Kioti bucket on the left of the first photo. Ideally, I would like the pin
spacing to be greater than Kioti uses, but less than used here.
2nd photo shows the brackets
cut off. That took about 30 seconds each
with the plasma cutter. I am not going to reuse them because I want a
closer pin spacing and the bushings are designed for 1" pins. I plan to use
my Kioti 25mm pins and 1.000 ID bushings.