TractorByNet.com - View Single Post

Taylortractornut · 01-05-2009, 04:09 AM

I usually dont buy HF tools but I was in the new store at Tupelo MS and saw the Tubing notcher they had. I had thought of building one and had a small tubing job that needed one on it. I wanted and Ole Joint Jigger but the 169 plus shipping was too much for the little job. I saw that one at HF and commented how good it looked. While I was next door looking at another job My wife slipped back in and bought me the notcher. Its well made and adjustable I do plan on adding a grease fitting to the bearing to make lubing better. It cut one sided a bit but it was only 1/8th off so I use adjusted it out with a couple washers.

01-05-2009, 04:09 AM	#443 (permalink)
Taylortractornut Veteran Member Join Date: Mar 2002 Location: Iuka Mississippi USA Posts: 1,614	Re: Harbor Freight Tools that don't suck I usually dont buy HF tools but I was in the new store at Tupelo MS and saw the Tubing notcher they had. I had thought of building one and had a small tubing job that needed one on it. I wanted and Ole Joint Jigger but the 169 plus shipping was too much for the little job. I saw that one at HF and commented how good it looked. While I was next door looking at another job My wife slipped back in and bought me the notcher. Its well made and adjustable I do plan on adding a grease fitting to the bearing to make lubing better. It cut one sided a bit but it was only 1/8th off so I use adjusted it out with a couple washers.