TractorByNet.com - View Single Post

rback33 · 04-20-2009, 05:34 PM

Good question Rusty. Bob is/was one of the more knowledgeable people when it came to these kinds of things. I think he ended up getting the banhammer IIRC, but he can be found on a couple other sites now. His views were not really true about non-standard measuring. Actually, the pivot pin has really long been the standard because not all attachments are designed the same. There are some other standards that are being measured now in addition to the pivot point.

04-20-2009, 05:34 PM	#5 (permalink)
rback33 Veteran Member Join Date: May 2003 Location: Kansas Posts: 1,349	Re: Mahindra 35 series Good question Rusty. Bob is/was one of the more knowledgeable people when it came to these kinds of things. I think he ended up getting the banhammer IIRC, but he can be found on a couple other sites now. His views were not really true about non-standard measuring. Actually, the pivot pin has really long been the standard because not all attachments are designed the same. There are some other standards that are being measured now in addition to the pivot point.