jerzeemaple
New member
- Joined
- Mar 5, 2017
- Messages
- 24
I知 trying to replace the broken shear pins on my used/ new to me/ BCS snowblower (post 1995 spline shaft) . Right side is simple, pin is simple the drive shaft sheer pin hole and turbine hole align perfectly and not a problem it痴 the left side turbine that is a problem. The pin is sheared already, however, the shaft and turbine turn as if the pin is present but no pin is visible. I pulled gear box off and sprayed solvent down the center of turbine to free any corrosion. It appears that the broken shear pin is preventing me from being able to get the turbine off of the shaft, there is a little slop and the shaft and turbine can move 1/8 or so along the shaft horizontally and up and down 1/8 spinning on the shaft and thats it, so I know they are not fused with corrosion. I cannot get the turbine off whatsoever and would definitely appreciate any thoughts or suggestions on this. Thanks