[DavidD]

Worked it pretty hard today moving clay to build up driveway base. I am impressed with the overall comfort of the tractor.
After I modified the seat bracket where I could slide the seat back against the fuel tank the controls all seemed to be positioned well.
I have a question for the Mahindra guys on here though.
While doing my normal pre use greasing, I consulted the book to make sure I didn't miss any grease points since this tractor is new to me. I can't find the grease zirks on the front axle pivot , they are shown in the book but I cant find them.
They didn't even drill the castings around the pivot bushings that I can see. Have they changed the design after the book was printed? If this isn't some type of sealed bearing/bushing, this is going to be a very squeaky tractor.Should I contact the dealer?