TractorByNet.com - View Single Post - Rear hydraulic on Kubotas the less expensive way

JerryG · 11-09-2003, 11:45 PM

It needs to be reasonably flat, but doesn't need to be as smooth of a finish as a surface grinder gives. A quick mill job is enough, like in the picture. The point is that the surface doesn't interfere with the o-ring seal and clamps even. Mill marks are fine.

11-09-2003, 11:45 PM	#23 (permalink)
JerryG Super Member Join Date: Apr 2000 Location: Northwest Arkansas Posts: 6,917	Re: Rear hydraulic on Kubotas the less expansive way It needs to be reasonably flat, but doesn't need to be as smooth of a finish as a surface grinder gives. A quick mill job is enough, like in the picture. The point is that the surface doesn't interfere with the o-ring seal and clamps even. Mill marks are fine.