TractorByNet.com - View Single Post - Too Much Pressure To Connect Hydraulics? Need Help

jjcc246 · 05-06-2005, 08:40 PM

i had the same problem one time and i learned my lesson. When you disconnect the loader shut the engine off and move the lever in all positions befor disconnecting the hoses. To get the hoses back on after i didn't do this (and i don't know if this is the approved method) i unscrewed the quick dosconnects to release the pressure. you lose some fluid and you might get a little dirty but it works. you might want to try shoving something blunt into the quick disconnects to release the pressure. you'll get them back on after a little effort and i bet you don't do it again. good luck

05-06-2005, 08:40 PM	#2 (permalink)
jjcc246 Silver Member Join Date: Sep 2004 Location: Buffalo, New York Posts: 230	Re: Too Much Pressure To Connect Hydraulics? Need Help i had the same problem one time and i learned my lesson. When you disconnect the loader shut the engine off and move the lever in all positions befor disconnecting the hoses. To get the hoses back on after i didn't do this (and i don't know if this is the approved method) i unscrewed the quick dosconnects to release the pressure. you lose some fluid and you might get a little dirty but it works. you might want to try shoving something blunt into the quick disconnects to release the pressure. you'll get them back on after a little effort and i bet you don't do it again. good luck