Results 1 to 3 of 3
  1. #1
    Bronze Member
    Join Date
    May 2007
    Posts
    55
    Location
    Berlin Center,Ohio
    Tractor
    Yanmar 336D

    Default 469 haybine ????????????

    Hello I have a new holland 469 haybine with conditioner ,well i was making my second cutting and started to have trouble with it .

    I was missing a lot of hay and would get clogged up at the cutter bar , would have to go in reverse to clear it thaen it would cut good and do the same thing again.

    I noticed my belt on the cutter bar is worn and needs replaced ,it is out of adjustment , also I would have to go so slow to cut the hay it took me forever to finish my field.

    Any one know how to correct this problem ?????????????

    thanks
    Greg

  2. #2
    Veteran Member
    Join Date
    May 2008
    Posts
    1,144
    Location
    A little southeast of Syracuse, NY
    Tractor
    Kubota

    Default Re: 469 haybine ????????????

    It could be several things. Did you check the bearing in the end of the cutter bar? As these go the stroke get short. Also are the knives sharp? Are the guards worn? Are all of the cutter bar hold downs in place and are the holding the knives against the bottom of the guards?

    I know there is probably more it could be, but these where the 1st things I used to check when one I used was having issues.

  3. #3
    Bronze Member
    Join Date
    May 2007
    Posts
    55
    Location
    Berlin Center,Ohio
    Tractor
    Yanmar 336D

    Default Re: 469 haybine ????????????

    thanks for the reply I am going to replace the cutter bar and ordered a new belt and i will check out the knife guards .

    thanks again for your help
    Greg

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.