Results 1 to 1 of 1
06-02-2013, 03:33 PM #1
- Join Date
- Jun 2013
- North Wilkesboro, NC
Sitrex model 2GL - Replacing Bearings
Just purchased an old Sitrex 2GL Tedder. The shaft in the gearbox has two worn bearings. Here are my questions:
(1) I finally removed the shaft and bearings out of the gearbox however, the gear came off in the gearbox. Will I have to pull the entire shaft that goes from one tedder basket to the other tedder basket to re-install the shaft in the gear?
(2) If so, how do I pull the shaft? The wheels support the tedder baskets and, looks like each "wheel shaft" has two roll pins, one pin with-in the other.
How do I remove the pins?
Or any advice would be appreciated.
By pharmvet in forum Parts/RepairsReplies: 2Last Post: 03-22-2012, 10:43 PM
By Johndeere3720 in forum Parts/RepairsReplies: 15Last Post: 12-07-2010, 08:27 AM
By kimodc in forum John Deere Owning/OperatingReplies: 1Last Post: 01-30-2010, 09:52 PM
By mark_torrey in forum Parts/RepairsReplies: 2Last Post: 11-15-2009, 11:06 AM
By eclarkva in forum AttachmentsReplies: 3Last Post: 08-25-2009, 06:00 PM