Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
Are any of you using a a removable tooth bar on a HD bucket that has already has a bolt-on cutting edge installed? My dealer tried to install one on my L35 that is designed for this (by Woods) and couldn't get it to fit. Woods sent me a drawing today that looks like the tooth bar only goes over the bottom of the cutting edge 1 3/4 inches and just sits on the sharp upper edge of the cutting bar on top.
The force looks like it is primarly absorbed by the two side runners that attach inside the bucket.
I'm wondering if this 1 3/4 overlap is normal. Doesn't seem like much.
del
[email]oldcarparts@mygarage.com [/email]
The force looks like it is primarly absorbed by the two side runners that attach inside the bucket.
I'm wondering if this 1 3/4 overlap is normal. Doesn't seem like much.
del
[email]oldcarparts@mygarage.com [/email]