croasdale
New member
I need to replace the shaft on my bush hog. Here's what I have...
A 1-3/8" splined shaft on the tractor PTO.
A 1-3/8" splined shaft on the hog.
I am thinking of replacing the old broken shaft with a new one at TSC. (#271318)
I have two questions...
Can I put a smooth bore yoke on the RC splined shaft and run a shear pin through them? I know it's not optimal, but I can't run a shaft with splined yokes at both ends unless I put a slip clutch in there which would then create new problems with shaft length and other issues.
What do the series numbers mean? TSC has shafts in series 14, 28, 35, etc.
Thanks
A 1-3/8" splined shaft on the tractor PTO.
A 1-3/8" splined shaft on the hog.
I am thinking of replacing the old broken shaft with a new one at TSC. (#271318)
I have two questions...
Can I put a smooth bore yoke on the RC splined shaft and run a shear pin through them? I know it's not optimal, but I can't run a shaft with splined yokes at both ends unless I put a slip clutch in there which would then create new problems with shaft length and other issues.
What do the series numbers mean? TSC has shafts in series 14, 28, 35, etc.
Thanks