johnk
Elite Member
- Joined
- Jun 7, 2003
- Messages
- 2,649
- Location
- western NY
- Tractor
- Kubota GST Grand L3130 w/ 723 loader, Ags
I lower the blade with the top link extended just so the hinged part has a little pressure on it. Experimentation is the key but that is a start for you.canoetrpr said:Johnk: I also ended up with the hinged back for the same sort of reason. Dealer ordered the wrong one but it ended up being the heavier duty model so I decided to keep it (about 100lb heavier).
It may be that my top link is not long enough to get to the point where the front blade does not cut.
How much weight is on your blade when you are doing this? Is your 3PT all the way down or are you adjusting it to only keep some weight on the surface but not all.