Replacing a cuttershaft bearing

ps7520 · 09-19-2008, 09:52 AM

I have to replace a blown cuttershaft bearing on a Mott 72 flail mower and I don't have a manual. It looks like I can support the mower and prop up the shaft, then remove the bearing & housing and replace it.

Has anyone here done this or have some insight on how best to go about doing this?

TIA

Peter

GreenWannabe · 09-22-2008, 04:20 PM

Mott was bought out byAlamo in 1983. You might try contacting either Alamo Industrial or Rhino and seeing if either could help you with a manual.

09-19-2008, 09:52 AM	#1 (permalink)
ps7520 New Member Join Date: Sep 2007 Posts: 21	Replacing a cuttershaft bearing I have to replace a blown cuttershaft bearing on a Mott 72 flail mower and I don't have a manual. It looks like I can support the mower and prop up the shaft, then remove the bearing & housing and replace it. Has anyone here done this or have some insight on how best to go about doing this? TIA Peter

09-22-2008, 04:20 PM	#2 (permalink)
GreenWannabe Silver Member Join Date: Jun 2006 Location: Northern Alabama Posts: 165	Re: Replacing a cuttershaft bearing Mott was bought out byAlamo in 1983. You might try contacting either Alamo Industrial or Rhino and seeing if either could help you with a manual. __________________ Retired now Last edited by GreenWannabe; 09-22-2008 at 05:29 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode