SPYDERLK
Super Star Member
- Joined
- Feb 28, 2006
- Messages
- 10,160
- Location
- VA
- Tractor
- JD2010, Kubota3450,2550, Mahindra 7520 w FEL w Skid Steer QC w/Tilt Tatch, & BH, BX1500
I run my 12/14KW with an L2550. It holds the gen speed +/- 5% regardless of load. This has presented no problem to appliances or computers. No glitch when the air compressor or AC comes on. I have had a problem with a standalone tho, that did not run steady under light load. It caused problems with electronics due to "hunting" rpm unless the gen was carrying at least a 25% load causing the rpm to be steady.You do realize that some appliances can be damaged by the wrong frequency and voltage. I would at least initially monitor these for each load so you know which loads present a problem. There are many variables here. For example if the generator is lightly loaded and you turn on a load you will probably have a greater voltage and frequency change then if the generator is 1/2 loaded and the same load is turned on. I don't have experience with this, but that is the theory. Does anyone here have direct experience with this? I was not sure from the other comments.
larry