sss
Bronze Member
I need to lower the 3pt pins on my 4ft rotary cutter to allow higher lift capability on my BX2200. I was about to drill holes in the 3pt frame when I noticied that the 3 pt frame was connected to the deck frame by 7/8" bolts. Couldn't I just remove the bolts and insert the pins in those holes where the pins would serve as the frame bolt and the hitch pins. There's plenty of room for hookup and raising/lowering without binding and this would make the pins about 3" further down from the point I had planned to drill. My Landpride 42" box blade is/was made that way with the 3pt frame attached to the box blade frame by the hitch pin bolts.