bill333
Silver Member
I bought this used rotary cutter. I'm a bit of a newbie and know that I'm supposed to have some kind of shear protection, like a bolt, but don't know where to find it.
Here is a photo of my PTO shaft and how it is connect to the cutter. As you can see the shaft is welded to the yoke.
(seperately, I'm trying to figure out how to disconnect the shaft from the yoke so I can replace it with a longer shaft)
Am I missing something -- is there supposed to be a slip clutch or a shear pin? Or is the thing marked "what is this" the slip clutch?
I assume if I don't have either then this is not a good setup to run?
Here is a photo of my PTO shaft and how it is connect to the cutter. As you can see the shaft is welded to the yoke.
(seperately, I'm trying to figure out how to disconnect the shaft from the yoke so I can replace it with a longer shaft)
Am I missing something -- is there supposed to be a slip clutch or a shear pin? Or is the thing marked "what is this" the slip clutch?
I assume if I don't have either then this is not a good setup to run?