Arky217
Silver Member
I'm making a set of chain on bucket forks for my pin on bucket for use mainly on brush, slabs, etc.
I'm using 2"x2"x1/4" sq. tubing and will be putting about a 30 degree angle on the points.
Trying to decide whether to put the slope of the angle up or down. I've seen them both ways.
Which way would you orientate the slope of the tips and why ?
Thanks,
Arky
I'm using 2"x2"x1/4" sq. tubing and will be putting about a 30 degree angle on the points.
Trying to decide whether to put the slope of the angle up or down. I've seen them both ways.
Which way would you orientate the slope of the tips and why ?
Thanks,
Arky