picker77
Gold Member
- Joined
- Feb 4, 2006
- Messages
- 385
- Location
- Central Oklahoma
- Tractor
- JD 3032E, dual remotes, TnT, tooth bar, grapple
Every time I look at my new JD 3032 I see something else that gets my curiosity up. This time it's "holes" again (photos attached).
1. There are three hefty threaded bosses on the 305 loader's cast iron mounting frame, but ONLY on the right side. What were they put there for? Looks like something pretty stout could be installed there, but I can't imagine what it might be.
2. There are four matching holes, two on each side, drilled through the main lift arm plates. Nothing has ever been in them, factory paint is untouched. Anybody know what these holes are for?
As usual, thanks for the help!
1. There are three hefty threaded bosses on the 305 loader's cast iron mounting frame, but ONLY on the right side. What were they put there for? Looks like something pretty stout could be installed there, but I can't imagine what it might be.
2. There are four matching holes, two on each side, drilled through the main lift arm plates. Nothing has ever been in them, factory paint is untouched. Anybody know what these holes are for?
As usual, thanks for the help!
Attachments
Last edited: