I bought my first tractor last week it's and 806 with a 2 pt hitch. I need to buy the arms to convert it to a 3 pt hitch. My question is the distance between the center of the two arms is 30 inches which I guess is not standard. What do I do? I bought a 3 pt bush hog and would like to be able to use it but can't at this time. Where can I find a 3 pt conversion for this. I guess standard distance is 26" or 32". I'm new to all this tractor stuff and my dad is on the road and can't offer his knowledge.
2 point to 3 point hitch
- Thread starter lstork
- Start date
sweettractors
Advertiser
We have those arms that are offset to put you back to category 1 spacing. Just call us to place your order. Ken Sweet
sweettractors
Advertiser
Generally speaking, however, We can get these with rollaball inserts, so they will work cat 1 or cat 2. Ken Sweet
sweettractors
Advertiser
Istork, Normally with that big 806 tractor, You would use straight tongs normally with catagory 2 (1 1/8 inch ball holes). We also stock a straight tong with a ball that has catagory 1 ( 7/8 inch and 1 1/8 inch all in the same ball) If you need to go narrow, you would use the bent tongs that are curved inward to be the same width as catagory 1 spacing or turn them outward for catagory 2 spacing. Ken Sweet
wcwasson
New member
I have a 756 International with two point, bought arms with ball that fit and all I need to do beside that was get a longer top link. Got that at Tractor Supply. They also make an sleve to go on three point lift points that enble you to use the two point as well. I use those when I use the rottery cutter.