replacing worn disks

[spo307]

I am refurbishing the jd kba disk I picked up. I took it apart and noticed the 3 inner disks ( front and rear gangs ) are severely worn.

1. do i have to replace all the disks or can I just replace the worn down ones?

2. is this wear from a miss alignment, or normal wear? thanks

 

[MMagis]

That's normal wear.
It's best to do all of them.

 

[sweettractors]

+ 1 for normal wear and replace all. Ken Sweet

 

[spo307]

NOW THE REAL QUESTION, WHERE TO GET THEM

 

[sweettractors]

Agri Supply - Farm Supplies, Tools, Lawn Mower Blades, Cast Iron Cookware Ken Sweet

 

[spo307]

KEN IS THERE AN ADVANTAGE IF I MADE THE REAR BLADES NOTCHED, OR SHOULD I KEEP THEM SMOOTH.

IF I MADE THE BLADES 16" INSTEAD OR 18"?

AND IS 3.5MM THICKNESS GOOD ENOUGH OR SHOULD I ORDER 4.5MM. LASTLEY DO YOU HAVE HANGERS AND SCRAPER BLADES?
THANKS DENNIS

 

[sweettractors]

KEN IS THERE AN ADVANTAGE IF I MADE THE REAR BLADES NOTCHED, OR SHOULD I KEEP THEM SMOOTH.

IF I MADE THE BLADES 16" INSTEAD OR 18"?

AND IS 3.5MM THICKNESS GOOD ENOUGH OR SHOULD I ORDER 4.5MM. LASTLEY DO YOU HAVE HANGERS AND SCRAPER BLADES?
THANKS DENNIS

If you have rocks, go with thicker bladee. Notched is more agressive, however, they dont last as long as smooth. Most like notched on the front and smooth on the back.
There are 4 different casting #'s for the hangers for the scrappers. Let us know the casting # you need and Qty and we will see what we can find. We have a very few scrapper blades. Ken Sweet

 

[spo307]

SCRAPPER BLADES i WILL FABRICATE IF I HAVE TOO

 

[spo307]

SO IF I GET THE 4.5MM BLADES THEY WILL FIT?

 

[clemsonfor]

i would think they would fit thats only a few mm per axle, your nut wont screw on as for i would think, but thats it.