Results 1 to 2 of 2
08-29-2011, 10:41 PM #1
- Join Date
- Jan 2005
- western Illinois
- 1968 gas Ford 3000
Changing wheel bearing on RFM
One of the gauge wheels in my Landpride 2572 RFM has seized up, so I assume that the bearing is bad. I'm trying to get to it to the bearing, but would like suggestion on how to remove the outer cover to get to the bearing -- #1 on the attached diagram. Anybody done this before?
08-29-2011, 11:21 PM #2
- Join Date
- Sep 2008
- NE USA
- JD LA115, WH 244, WH 525 hydro-pops,Original Troy Built Horse 8 HP
Re: Changing wheel bearing on RFM
So you have the heavy roller bearing which is good. you need a long punch to push out the far cap and then the bearing should fall right out after you remove the wheel from the hub.
Use a very thin flat screw driver to pry the cap off and then you can use the long punch if needed. These heavy roller bearings are really nice.
By Lockport in forum Owning/OperatingReplies: 65Last Post: 07-06-2011, 11:58 AM
By DSinOR in forum Kioti Owning/OperatingReplies: 10Last Post: 10-14-2007, 11:23 PM
By accordionman in forum Massey Ferguson Owning/OperatingReplies: 5Last Post: 04-04-2007, 08:55 PM
By tinytractors in forum Owning/OperatingReplies: 9Last Post: 03-26-2005, 09:48 AM
By wroughtn_harv in forum ProjectsReplies: 9Last Post: 02-01-2003, 11:16 PM