I am wondering if there is an auger that fits in place of the front bucket, like skid steers. It must fit on a Kabota BX25. I know there was a snowblower that ran on the rear pto and now they have a blower that fits on the front, so I was hoping someone is making a from auger as compared the weird rear pto one that is out there.
BX25 front auger
- Thread starter sunnyboy
- Start date
kennyd
Advertiser
Welcome to TBN
Short answer: No, the BX will not have enough hydraulic capacity to operate the PHD.
Short answer: No, the BX will not have enough hydraulic capacity to operate the PHD.
Wacky
Veteran Member
Yep....what he said^^ I checked too!!
ultrarunner
Epic Contributor
- Joined
- Apr 6, 2004
- Messages
- 22,938
- Tractor
- Cat D3, Deere 110 TLB, Kubota BX23 and L3800 and RTV900 with restored 1948 Deere M, 1949 Farmall Cub, 1953 Ford Jubliee and 1957 Ford 740 Row Crop, Craftsman Mower, Deere 350C Dozer 50 assorted vehicles from 1905 to 2006
Someone around here did mount a second hydraulic pump on the belly mower PTO and another person fabricated an adaptor to use the backhoe bucket mounting for the auger motor.
bindian
Super Member
Check out Danuser Augers. The 8300-1 should work if your BX25 puts out 6 gpm.
http://www.danuser.com/PDF/ag_brochure.pdf
I have the 8300-2 and love it. I fixed it to mount on my backhoe, but will get the bracket to mount on my loader bucket, on the side.
hugs, Brandi
Attachments
DDT
Platinum Member
- Joined
- Dec 18, 2000
- Messages
- 966
- Location
- Clay Center, Kansas
- Tractor
- Kubota M6040/cab, BX25D, RTVX900
Land Pride makes one for 5 to 12 gpm tractors
Land Pride HD25 Post Hole Diggers
works great on my9.9 gpm tractor
Land Pride HD25 Post Hole Diggers
works great on my9.9 gpm tractor
kennyd
Advertiser
I stand by my original post, the BX series only flow 3.7 GPM to the loader circuit.
DDT
Platinum Member
- Joined
- Dec 18, 2000
- Messages
- 966
- Location
- Clay Center, Kansas
- Tractor
- Kubota M6040/cab, BX25D, RTVX900
Kennyd, sorry I seen 6.6 gpm on kubota web site, did I over look a line?
bindian
Super Member
Kenny,
This is what I was going by also. Nice hearing from you again.
I am moving my auger to a front bucket mount, but will be using the rear remote to power it, like the backhoe. So, this should work for him, right?
hugs, Brandi
kennyd
Advertiser
Kenny,
This is what I was going by also. Nice hearing from you again.
I am moving my auger to a front bucket mount, but will be using the rear remote to power it, like the backhoe. So, this should work for him, right?
hugs, Brandi
Look at the .pdf attached below from the Kubota site at this link: Tractors | BX Series| BX1860/BX2360/BX2660/BX25
The total GPM for the pump is indeed 6.3, but if you look on the second page under the loader specs it list's the flow at 3.7 GPM for the loader. The difference between the two figures is dedicated to the steering system through a priority valve.