Hi, I just bought a used Bush Hog 2510 and am trying to match it up to my Ford 5900. My question is this, in the on line bush hog manual it appears the pull bar point must be 14 inches past the PTO shaft on the tractor. It also says you must have at least 6 inches of overlap in your driveshaft. The way my pull bar is right now, I only have about 2 or 3 inches of the one shaft inside the other. I know I can move my pull bar in some, but I would need to move it in at least 4 inches to have the adequate lap, but this may only leave me 12 inches or so of distance from the shaft to the pull bar center hole. Will this work, or do I HAVE to stick to the 14" recomendation?? Thanks for any help