dgleason
New member
Bought a King Kutter 3 pt. Trailer Mover to move my trailers around the yard. This takes a "standard" 2" ball mount according to all the specs I read. Literature says use the same ball mounts you use with your truck. After delivery, I put the lift pins on the outside, and then found it would not accept either of my 2" ball mounts I've been using for years.
Got the following measurements with my digital caliper:
King Kutter receiver tube - 2"
Chev truck receiver tube - 2 5/32"
Both ball mounts inserts were 2 1/64". Can't slide 2 1/64" into a 2" opening.
Went to the auto store and found an insert that was 1 63/64". It works fine now. The King Kutter also fit my iMatch hitch too. So I'm good to go now.
My concern is I would think a "standard" receiver tube and ball mount insert regardless of brand name would be inter-changeable. Couldn't find a spec for these on the internet.
Got the following measurements with my digital caliper:
King Kutter receiver tube - 2"
Chev truck receiver tube - 2 5/32"
Both ball mounts inserts were 2 1/64". Can't slide 2 1/64" into a 2" opening.
Went to the auto store and found an insert that was 1 63/64". It works fine now. The King Kutter also fit my iMatch hitch too. So I'm good to go now.
My concern is I would think a "standard" receiver tube and ball mount insert regardless of brand name would be inter-changeable. Couldn't find a spec for these on the internet.