I snapped off my pto shaft on my b7100 and now I begin to think the reason why was because I never adjusted my pto shaft to the tractor when I bought my brush hog. I drove over a log, it raised the BH and the pto snapped.
I fixed it taking advice from this site, but then realized I never gave the shaft a second thought when I bought the BH. Was it too long?
Is there a methodical way to check the length for proper operation?
I fixed it taking advice from this site, but then realized I never gave the shaft a second thought when I bought the BH. Was it too long?
Is there a methodical way to check the length for proper operation?