Results 1 to 2 of 2
  1. #1
    Super Member RobS's Avatar
    Join Date
    Jun 2000
    Posts
    6,655
    Location
    SW Michigan
    Tractor
    John Deere 790

    Default Box blade blades

    I've noticed on my King Kutter box blade that the front cutting edge is lower than the rear (by about 3/4") when the top of the end plates etc. is horizontal. This means I really have to crank the top link out to pull the front edge up for smoothing. Is this typical?

    Rob

  2. #2
    Epic Contributor Bird's Avatar
    Join Date
    Mar 2000
    Posts
    39,312
    Location
    Texas

    Default Re: Box blade blades

    Rob, I think all the ones I've seen were even. And the front and rear cutting edges should be identical, as well as reversible. One possibility that I've seen is for the bolts holding the cutting edge on to get loose, then get dirt or gravel jammed in under the cutting edge that holds it in an unnatural position.

    Bird

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2016 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.