KnuckleDragger
Bronze Member
I have one of the older designs of the 2615 batwing. The primary difference between my old version and the newer is that the height adjust cylinder on the new is at the back of the deck. Mine is at the front. I am lacking a users manual and need to determine how to adjust the minimum and maximum height. Basically, its low is nearly scalping, and its high is about 10". I want it higher.
As far as I can tell, I need to crank a turnbuckle that is that is attached between the deck and the neck. In order to do so, it appears that I need to remove the turnbuckle bolt, jack up and block both the front and rear end, extend (retract?) the cylinder, and crank the turnbuckle until the turnbuckle aligns with its pin bolt again.
Does anyone out there have an older 2615L (or similar) that can confirm this operation? Or perhaps have a manual they would be willing to sell?
Thanks,
Chris
As far as I can tell, I need to crank a turnbuckle that is that is attached between the deck and the neck. In order to do so, it appears that I need to remove the turnbuckle bolt, jack up and block both the front and rear end, extend (retract?) the cylinder, and crank the turnbuckle until the turnbuckle aligns with its pin bolt again.
Does anyone out there have an older 2615L (or similar) that can confirm this operation? Or perhaps have a manual they would be willing to sell?
Thanks,
Chris