pharmvet
Platinum Member
- Joined
- Sep 28, 2008
- Messages
- 535
- Location
- North East TX
- Tractor
- Ford 7710 II FWA, NH TB110 FWA w/ NH 46LB loader, JD 5303 2wd w/ loader
This will be my second year to use my 10' Rhino pull behind shredder. I will be using it behind my 7710 Ford. Last year I tried very hard to keep the CV joint well greased but it wasn't until the 2nd or 3rd time I greased it up, that I actually found the zirk for the CV joint. I had only been greasing the U joint. Anyway, during my mowing last fall, I noted that I would hear a faint click, click in the drive line when I would turn. I purposely did not turn very sharp, but I would hear this sound if I turned a little bit sharp. Is this normal? Is the sound my CV joint, or could the drive line on my shredder need shortening? Im planning to start shredding again soon and want to prevent any problems. I would like your feedback. thanks