durango1700
New member
- Joined
- Nov 10, 2007
- Messages
- 11
I bought a used one at auction and want to rebuild/repair the impeller. Looks like they used it to throw gravel and rocks.
Anybody out there know how to get the pto drive shaft off? I already removed the bolt and the two allen screws, but it won't budge. Between that and the tractor is an orange ring that also had an allen set screw.
Are there any other tips to completely take this apart? I know I have to remove the auger to get to the impeller.
Figure I'll give everything a sandblast/wire wheel and repaint too. That sure helped with my loader and rear blade, snow didn't stick to the fresh gloss paint last winter. Also going to try and mechanize the chute rotation and chute angle while I'm at it.
Any help would be greatly appreciated.
Thanks.
Anybody out there know how to get the pto drive shaft off? I already removed the bolt and the two allen screws, but it won't budge. Between that and the tractor is an orange ring that also had an allen set screw.
Are there any other tips to completely take this apart? I know I have to remove the auger to get to the impeller.
Figure I'll give everything a sandblast/wire wheel and repaint too. That sure helped with my loader and rear blade, snow didn't stick to the fresh gloss paint last winter. Also going to try and mechanize the chute rotation and chute angle while I'm at it.
Any help would be greatly appreciated.
Thanks.