I'm getting a new tractor, what is a good box blade set up I should get? Mahindra3550

[joe t]

You must sell tractors.

[JD 4520]

Looks good.

I'm going to ask them to set up a couple auxilaries. Gonna make the deal I want then tell them this is necessary . Don't want to push my luck too much.

They will if they make money and won't if they don't but why not be up front?

[joe t]

Just my experience, best to ask after or you'll pay more than it would cost to just take it some place else. If I can't use the tractor then I won't do the deal. If it is that complicated then charge me. If it costs 30 mins and a few bucks in parts they should just throw it in.

[jenkinsph]

You must sell tractors.

Nope, do plumbing and dirt work for a living. Here's my boxblade setup.

[MtnViewRanch]

mtviewranch, who makes the hydraulic multiplier you installed? That is the exact setup I am looking to install on my tractor. Thanks.

Me, how many do you want?

[Yupkwondo]

Me, how many do you want?

Same setup you show, one into three.

[MtnViewRanch]

Same setup you show, one into three.

So you need 4 rear remotes? What tractor is this going on?

[Yupkwondo]

So you need 4 rear remotes? What tractor is this going on?

Three rear remotes total, I currently have one open to feed the multiplier; the others are hard lined into the top and tilt cylinders. Its going on a Kubota L5740

[MtnViewRanch]

Three rear remotes total, I currently have one open to feed the multiplier; the others are hard lined into the top and tilt cylinders. Its going on a Kubota L5740

So you actually have the 3 OEM remotes and you need to be able to have 5?

[Yupkwondo]

So you actually have the 3 OEM remotes and you need to be able to have 5?

Correct