Are you Happy with your Clamp on Pallet Forks?

   / Are you Happy with your Clamp on Pallet Forks?
  • Thread Starter
#22  
   / Are you Happy with your Clamp on Pallet Forks?
  • Thread Starter
#24  
   / Are you Happy with your Clamp on Pallet Forks? #27  
I bought a nice set couple years ago and I really like them...
Lots less expensive than other options...
You can move a lot of brush with the 2x4 standards in the back of the fork...
Best addition to my FEL since my FEL...
 
   / Are you Happy with your Clamp on Pallet Forks? #28  
I just ordered these: Amazon.com: Clamp on Pallet Forks for Loader Tractor or Skid Steer (COF): Home Improvement

So I'll have to wait a while to test them, but the reviews all look good and the price was great. 4000 lb capacity, $189 with free shipping.

That is the set I purchased a couple years ago...
Excellent product...
You will be very well pleased with them...
One thing I did do was cut two shims to go in between the hold down screws...
These were cut on my metal cutting bandsaw...
I think that they are 2x2x3/8...
I keep them with the forks...
 
   / Are you Happy with your Clamp on Pallet Forks?
  • Thread Starter
#29  
Well perhaps I Paid to much fo mine. It came with a stabilizer bar though. The sent the wrong one and I emailed them. They were real nice and said they shipped the correct one this afternoon. I used them today. I didn't get too carried away. I picked up four 1 foot in diameter logs that were about 7 feet long. No problem there so that alone makes it worth it.
 
   / Are you Happy with your Clamp on Pallet Forks? #30  
If you don't mind drilling four holes in the bottom of your bucket, you can easily make a pair of forks that bolt to the bottom of the bucket fairly quickly. Two holes per fork. No lateral stability problem. On or off in a couple of minutes. My set only stuck out about 18 inches but was handy for stacks of railroad ties or sheets of plywood on edge, leaned against the bucket face.

I should add that if you make your own bolt-on forks, make sure the hole pattern is identical on both forks. Otherwise, you'll end up with left and right forks to deal with. Don't ask.
 
 
 
Top