spruce Deere
Veteran Member
- Joined
- Feb 1, 2009
- Messages
- 1,079
- Location
- Northmost Idaho
- Tractor
- John Deere 790 with loader LS xr3140h also with loader plus a cab
Turned up an old but good shape 2 bottom case eagle hitch plow. Looking and measuring the 'eagle hitch' over and up, pretty sure I can make it a normal cat 1 set up fairly easy.
There is CX16 stamped on the back of the plow, and thats it for any identification I can find anywhere. Colors whats left, are green on the hitch stuffs and orange or prolly case "flambeau red" on the plow stuffs I did not measure the shares but they do look to be 16" long.
There is no Coulters, but it dose have a steel tail wheel that spins as if you had just put new bearings in it.
Anybody know wheres about getting new shares or maybe some info for such such a thing?
I'm a feared that 2 16" plows could be to much for the 790....can unbolt the rear moldboard and run just one if that turns out to be an issue, not that I want too
There is CX16 stamped on the back of the plow, and thats it for any identification I can find anywhere. Colors whats left, are green on the hitch stuffs and orange or prolly case "flambeau red" on the plow stuffs I did not measure the shares but they do look to be 16" long.
There is no Coulters, but it dose have a steel tail wheel that spins as if you had just put new bearings in it.
Anybody know wheres about getting new shares or maybe some info for such such a thing?
I'm a feared that 2 16" plows could be to much for the 790....can unbolt the rear moldboard and run just one if that turns out to be an issue, not that I want too