Bent FEL foot.

   / Bent FEL foot. #1  

wedge40

Veteran Member
Joined
Oct 8, 2007
Messages
2,195
Put the FEL on after having it off about 6 months. Kind of tricky when you're by yourself. Finally got the FEL on, hooked up and pinned in place. But forgot to remove the foot/stand. Buy the time I figured it out I have bent it. Should I purchase a new one or could this be heated and straightened back out?

Wedge
 
   / Bent FEL foot. #2  
Don't know for sure... did it bend enough to collapse back upon itself? Or does one side or another have a crack? I'd think that you could likely straighten it.. another question would be - will it reliably support the loader weight without bending or breaking and causing the loader to fall over.

You might have to plate it or slide a new section of square tubing or round stock over the top of the bent area and welding it.

AKfish
 
   / Bent FEL foot.
  • Thread Starter
#3  
No Kinks in the pipe. I'll post photo later today.

Wedge
 
 
 
Top