Want to make ball hitch attachment for the three point lift, Any made?

[Ehanson]

I have a Cat 1, 3 Pt Hitch, I want to put a ball on a cross member and mount it between the lower arms of the 3PH.
Any have any pics of one they have made?
I will build it, but I am thinking of hitch geometry and such?
Thank you

[Pooh_Bear]

Like one of these?
CountyLine® Trailer Mover - Tractor Supply Online Store

Or here are some ideas....
Power Takeoff (PTO) + 3-Point Hitch Hardware | Farm + Acreage | Northern Tool + Equipment

Pooh Bear

[EverythingAttachments]

We make a receiver hitch for pull type trailers and a model that works for pull type and gooseneck trailers. The receiver for pull type trailers is available in a standard and subcompact model. The gooseneck receiver is Category 1 quick hitch compatible. All of our receiver hitches ship free to your home within 1,000 miles of Newton, NC. If you're outside the free zone, just give us a call for a quote.
Travis

[aczlan]

We make a receiver hitch for pull type trailers

I have this one (thanks again for it) and it is quite beefy.

Aaron Z

[Ken45101]

Here is one that I did as an early welding project. The welding could be a lot better, but it will give an idea of one approach. Note, the weight and pull is on a heavy duty drawbar, so it should hold. My welds are just keeping it upright.

[yeagisyeag]

Here's the thread I posted after making mine: My 3 point trailer hitch project


If I were to do it again, I would put the hitch on the inderside, then bolt through the drawbar into a plate on top, which I would weld the vertical part.

Jim

[LD1]

You either need to get one like others have posted, or you need an anti-rotation bracket if you only use the lower arms like you are talking about doing

[Xfaxman]

I have a Cat 1, 3 Pt Hitch, I want to put a ball on a cross member and mount it between the lower arms of the 3PH.
Any have any pics of one they have made?
I will build it, but I am thinking of hitch geometry and such?
Thank you

I liked this design so much that I bought one!

The top receiver makes it very versatile.



Got it from: OMNI Mfg LLC

[bhh]

I just bought this one last week to tow a large chipper around in the woods. I already had the drawbar so this was the cheapest option by far and worked great.
EMP Tractor Draw Bar Stabilizer for Category 1 Tractors, Model# 7350-1 | 3-Point Drawbars Stabilizers| Northern Tool + Equipment

Edit: My only complaint is that it wouldn't fit my quickhitch but it won't be too tough to modify it to fit.

[Runner]

Here's mine. Also is the basis for a boom pole.