Results 1 to 4 of 4
  1. #1
    New Member
    Join Date
    Sep 2013
    Roosevelt, UT
    Montgomery Ward Lawn Tractor

    Default Montgomery Ward Lawn Tractor tiller

    I stripped a bearing on our tiller. I was able to take it apart and thought I would be able to put it back together without too much trouble. However, the housing will not fit back together, there is a gap. On one side there is a bearing and two spacers. You can tell that they are in the correct place on how they have worn. On the other side there is just the bearing. I have attached pictures. Any ideas how to put this back together?
    Attached Thumbnails Attached Thumbnails Montgomery Ward Lawn Tractor tiller-img995-jpg   Montgomery Ward Lawn Tractor tiller-img996-jpg   Montgomery Ward Lawn Tractor tiller-img997-jpg   Montgomery Ward Lawn Tractor tiller-img998-jpg   Montgomery Ward Lawn Tractor tiller-img999-jpg  

    Montgomery Ward Lawn Tractor tiller-img1000-jpg   Montgomery Ward Lawn Tractor tiller-img1001-jpg  

  2. #2
    Elite Member Briana03's Avatar
    Join Date
    Jul 2010
    San Diego, California

    Default Re: Montgomery Ward Lawn Tractor tiller

    Welcome to TractorByNet!

    I moved your thread to the Attachments forum.
    TBN Support

  3. #3
    Gold Member
    Join Date
    Jun 2011
    S.W. Missouri
    LS U5030C w/FEL

    Default Re: Montgomery Ward Lawn Tractor tiller

    Not trying to be a smart aleck, but if you leave it out in the rain anymore and don't dry it off, it's not going to be worth putting back together.
    LS U5030C w/FEL, Bush Hog 307, Modern 7' industrial grade box blade w/hydraulic rippers, Rhino SPHD PHD, 48" Wildkat grapple, 72" Ratchet Rake, 6' King Kutter II tiller, 10' International Disk with hydraulic lift, 7' Vulcan double axle cultipacker, 76" W.R. Long bucket tooth bar.

  4. #4
    Super Member woodlandfarms's Avatar
    Join Date
    Jul 2006
    Los Angeles / SW Washington
    PowerTrac 1850, Kubota RTV x900

    Default Re: Montgomery Ward Lawn Tractor tiller

    Incorrect bearings is my guess. From the picture I think the bearings you have are taller than the original. I assume you compared before install? Did you replace the sleeve as well?
    Power-Trac 1850, grapple, hoe, 90" mower, 72" box blade

Similar Threads

  1. Montgomery Ward lawn tractor
    By Anonymous Poster in forum General Lawn & Garden
    Replies: 24
    Last Post: 10-18-2015, 04:42 PM
  2. montgomery ward
    By bushwacker45 in forum Parts/Repairs
    Replies: 3
    Last Post: 07-25-2013, 12:20 PM
  3. montgomery ward
    By bushwacker45 in forum Owning/Operating
    Replies: 1
    Last Post: 04-30-2013, 01:20 PM
  4. Is Sears Going The Way of Montgomery Ward?
    By Bird in forum Craftsman / Sears
    Replies: 50
    Last Post: 04-14-2012, 08:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
© 2018 TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.