FatTire
Veteran Member
- Joined
- Oct 2, 2007
- Messages
- 1,354
- Location
- Colorado
- Tractor
- Kubota L5740, Unimog 404 w/ snowblower, Deere 620i UTV, MX5100 (sold)
I have to run a pair of hoses from my rear remotes to a SSQA snow plow. There is plenty of space for routing from the remotes to mount for the FEL, then it gets a little more tricky on the arms. The plow has Flat-faced couplers which will reach about 3 feet up the FEL arm behind the SSQA plate. (This point changes depending on the height of the FEL, etc.) During the winter, I will disconnect at that point when I want to use the bucket.
I have a couple of routing options for the hoses on the FEL arms, but neither offer anything close to the protection of the factory set up. Also thinking of putting sheaths around the hoses (or is better to use one sheath to enclose both hoses?). Any good ideas for a clean set up? FYI- the tractor is a Kubota MX5100 with LA844 FEL.
I have a couple of routing options for the hoses on the FEL arms, but neither offer anything close to the protection of the factory set up. Also thinking of putting sheaths around the hoses (or is better to use one sheath to enclose both hoses?). Any good ideas for a clean set up? FYI- the tractor is a Kubota MX5100 with LA844 FEL.