2Buckslake
Member
Wanted to know if anyone out there can answer this question about bolt on toothbars. I have a 2006 TC45DA tractor with a 72inch bucket. I have a factory added reversible cutting edge that is bolted to the bucket, these holes along the inside of the bucket lip were already there when I purchased the cutting edge, and it bolted in place with no problem. It seems that New Holland is the only one I can find that has a tooth bar available that will bolt on over the existing added cutting edge. I really don't want to remove the cutting edge to install a tooth bar. Has anyone ran into this issue, and if you did, did you just drill out the flat plate on a tooth bar and use longer bolts to attach it and the cutting edge together in the bucket?