Pat's Easy Change Pat's Easy Change System - Order Online!

[GaryS]

I got a set of these a week or so ago and just now am getting around to the install.

Anone know if the install instructions are avaiable online? I seem to have lost the paper somewhere between the house and the barn....

Also, IIRC, the instructions said to install the shims with a barrel pin. There was no barrel pin in the package - is that normal?

 

[GaryS]

I got a set of these a week or so ago and just now am getting around to the install.

Anone know if the install instructions are avaiable online? I seem to have lost the paper somewhere between the house and the barn....

Also, IIRC, the instructions said to install the shims with a barrel pin. There was no barrel pin in the package - is that normal?

Nevermind - after a trip to the hardware store and a bit or trial and error, I got them installed.

 

[thunderworks]

I have a Kubota L5030 with top-n-tilt . . . are there any compatability issues with the t-n-t. I've read several posts that indicate problems with the lenth of the top link.

Rick

 

[Smithla]

I purchased the Pat's Quick Change system a couple years ago, and a few weeks ago I upgraded my tractor, so I removed the units and saved them for my new tractor. Well wouldn't you know it they wouldn't fit, so I contacted Pat, and behold they shipped me a new set that fit perfectly, and I shipped the old ones back. The only charge was $25, and I am astounded at how gracious they were. This is the kind of company I like to deal with, over and over again.

If anyone is hesitating ordering a set, go ahead, you won't be sorry.

Regards,

 

[milkman]

Now that's takin care of business, good to know there's still people out there like that.

 

[flINTLOCK]

I have read this thread from beginning to end. Everyone criticizes the poor instructions provided with the system. I've heard that for over 2 years now since I discovered this site when thinking about CUT purchase. Most all purchasers enumerate the quirks and difficulties encountered in installation.Yet, most if not all finish their comments by saying that they only wish they had done it sooner!! Why don't they improve the instructions?? How tough can that be?? I'd like to invest in a set to start off my tractor owning saga. Am I likely to run into any predictable problems installing on 2002 TC40D with telescopic lower link?? I should be taking delivery at end of March and would like to get things lined up. Ha Ha, that's a joke. Maybe not a good one!! A little quidance would be appreciated. Thanks

 

[Kendall69]

If apt spends two minutes reading this thread she will realize they are losing sales.
Me especially do not want problems with installs, and when everyone on the planet says " the instructions are miserable" - I say no way am I going to buy the product. Granted everyone did figure it out, but with my luck I'd be throwing the whole shootin match in the rubbish.

 

[flINTLOCK]

I was planning to order a set, but have held off because of everyone's comments about directions. I don't have time to "figure it out for myself"

 

[Inspector507]

Sure, the directions weren't the best, but if I can do it, anyone can. And I have loved them for the last 3-4 years.

 

[PATG]

The instructions were redone a little over a year ago. We strived to address all concerns. They now have illustrations, which makes it a lot simpler. We have put them on our website so you can review them before purchasing. I will be happy to email or fax them to anyone that wants them. If anyone has any more suggestions on how to make them more user friendly, just let us know. Thank you for all your past and future patronage.