Rake Harley Rake parts

[bunkydad]

I recently bought a used Harley Rake Model TR36. Is there a source for the owners manual or parts drawings? It looks in good condition but before I begin using it, I want to make sure everything is as it should be.

I watched Ted's video and he mentions "smoking the clutch". That's the primary reason I want a manual. I'd hate to break the drivetrain on my new tractor.

 

[J_J]

Try here.

Customer Service (8:00am 5:00pm CT)
Harley Attachments, LLC
PO Box 230
Jamestown, ND 58402-0230
701-252-9300
800-437-9779
Parts Fax: 701-952-9307
Email: harleycs@harleyattachments.com

https://www.youtube.com/watch?v=GzxTa2odFFI

 

[bunkydad]

Thank you. I called Kevin at customer service and he emailed me the owners manual before I was off the phone.

 

[J_J]

By smoking the clutch, I think he is talking about new clutches that have been coated with a protectant as it may sit out in the weather for months or years.

By loosing the nuts and springs, you release enough pressure that the clutch will spin if you bury the rake in the ground and rev up the tractor and let the varnish burn off, therefore the term smoking the clutch.

Then retighten the nuts to specs, and you are good to go.

If it is a used one, you might not have to smoke the clutch.

You could disassemble the clutch and look at the condition of the clutch pads.

 

[bunkydad]

Will do. Thank you. I took a look at the gear box last night and it needs to be drained. Filled with water and "milk". I'll try to post a few pics tonight of the clutch assembly.

 

[bunkydad]

I have a question on the clutch. The top picture is the rake I have. I see the clutch is slightly different in another rake. Do they work the same way?

 

[bunkydad]

Here are a few pictures of the clutch assembly. Do I loosen up the bolts on the assembly then "burn" it?

 

[bunkydad]

I attached a link to a video of the Harley Rake. When the bottom roller turns, it makes a noise. Any ideas?

 

[Stonehaller]

Here are a few pictures of the clutch assembly. Do I loosen up the bolts on the assembly then "burn" it?View attachment 396311View attachment 396312View attachment 396313View attachment 396314

Loosen the six bolts around the outside. Item 8 in the attached parts diagram.

 

[Stonehaller]

I attached a link to a video of the Harley Rake. When the bottom roller turns, it makes a noise. Any ideas?

Try loosening the bearing mounting bolts for the roller support bearing opposite the drive side. Rotate the roller to allow the bearing to align itself and the carefully retighten.