Pat's Easy Change Pats easy change system?

[_RaT_]

What are your thoughts about Pats easy change system? I have passed the link on to some folks that really like the idea. At less then $200, they thought the price a small factor if the product works. Common sense seems to evoke an idea of pure simplicity, what about actual use? It sure would make sense for me if my L3830 HST wasn't already so simple. Thanks in advance. Mark

 

[dieseldoc]

i installed the pat's system last week,i have only used it once and it is so much easier to hook up it is well worth the price!!

 

[_RaT_]

Thanks, Mark, I will pass that on to the folks. Rat.

 

[GaryM]

I've had mine since fall and think it works fine. I no longer have to wrestle implements back and forth to get the link pins lined up.

 

[Bob_Skurka]

I installed my Pat's in late summer on a TC24D and love it. I bought the optional cross brace/stabilizer bar, but I have not had to use it. I've seen some other posts on TBN where people swear by the optional bar. Basically Pat's Easy Change is as simple as it looks and it works. The instruction sheet that comes with Pat's leaves a lot to the imagination, but if I can figure it out, I think any one should be able to.

 

[HammerFour]

I put Pat's system on my little Kubota and I really like it. I really like the ease of use and simplicity of it.

 

[gadgetman]

Just got mine mounted on my M4900 this past week-end (see my other post this section). Other than the pin problem, I think the product is well made and should work great. Anything has got to be an improvement over trying to align everthing by yourself. Have not hooked up anything yet. My stabilizer bars should keep everything in alignment.

 

[dieseldoc]

FYI,i just saw the pats system being sold through Northern Tool and Hyd.,the price on the cat 2 was the same as pats but the cat1 was $20 higher(both were $199