I have a Bushog 286 and I have a question about the rear wheel. The wheel is attached to the rear of the Bushog with a heavy steel A frame. There is a tube at the rear of the A frame and then there is a pin that goes through the tube and the wheel assembly is attached to this pin. There is a grease fitting on the tube for lubrication.
Question is this-- is there supposed to be slop between the pin and the tube that it goes through? If I lift my Bushog off the ground and shake the wheel back and forth there iis slop between the pin and the tube. is it supposed to be loose like this or is supposed to be a tight fit?
Is there a bearing in this tube pin assembly or is it simply the pin within the tube. I have not noticed this before and was wondering if something was wrong.
Thanks
Question is this-- is there supposed to be slop between the pin and the tube that it goes through? If I lift my Bushog off the ground and shake the wheel back and forth there iis slop between the pin and the tube. is it supposed to be loose like this or is supposed to be a tight fit?
Is there a bearing in this tube pin assembly or is it simply the pin within the tube. I have not noticed this before and was wondering if something was wrong.
Thanks