Brian Kurtt
New member
First off, I'm sorry for the ignorant question.
I bought a used Cone Spreader and find that it is too close to the tractor. Maybe the arms are spread too wide? Maybe the dang spreader is just too big? If I cut the PTO Shaft to allow for when it is in the up/run position it will have about 5" of square spline - then there will only be an inch of square spline when its down. Of course it wouldn't be used in the down position so does it matter? Maybe there is a different style of pto shaft that ujoint/shaft splines are smaller and allow for a longer square spline. Any wisdom you'd care to share will be appreciated.
I bought a used Cone Spreader and find that it is too close to the tractor. Maybe the arms are spread too wide? Maybe the dang spreader is just too big? If I cut the PTO Shaft to allow for when it is in the up/run position it will have about 5" of square spline - then there will only be an inch of square spline when its down. Of course it wouldn't be used in the down position so does it matter? Maybe there is a different style of pto shaft that ujoint/shaft splines are smaller and allow for a longer square spline. Any wisdom you'd care to share will be appreciated.