PTO shaft question

[DMF]

This is probably a dumb question but I haven't had any luck searching on my own. I have an old WoodEze wood processor that is driven by a Prince PTO pump. I really hate wrestling this pump on and off my tractor. I'd like to mount the pump to the processor and drive it with a short PTO driveshaft. Easy enough.... But what I need is a shaft with a female end to connect to my tractor with a male tractor style shaft to go into my pump. Does this exist or will I need to cobble something up?

Thanks in advance for the help!

 

[George2615]

I know they make a PTO shaft with the 6 spline female on each end but then you would need a 6 spline male to male shaft to connect the pump to the PTO female. I searched a little but could not find one.
Here's the PTO shaft w/ female on each end.
Shaft, 1-3/8 in. 6-Spline x 1-3/8 in. 6-Spline F|EUROCARDAN

 

[DMF]

I know they make a PTO shaft with the 6 spline female on each end but then you would need a 6 spline male to male shaft to connect the pump to the PTO female. I searched a little but could not find one.
Here's the PTO shaft w/ female on each end.
Shaft, 1-3/8 in. 6-Spline x 1-3/8 in. 6-Spline F|EUROCARDAN

Link doesn't work for me? Maybe they make a 6 spline male shaft somewhere?

 

[George2615]

I tried a couple times and copied the link from Agrisupply.com but when I save the link and post it the link changes to viglink?.
I searched for 1 3/8 -6 spline x 1 3/8 - 6 spline PTO shaft.
Agrisupply has it.

agrisupply.com/pto-shaft-spreader/p/31963

 

[DMF]

That one worked; thanks! It states max HP as 540/1000 16/25? Is that correct?

 

[M5farms]

the male end should come off the pump . just buy a u joint on one end that fits the shaft and key with the female end on the other to hook to the tractor. You can buy loose parts at tractor supply and just roll pin them or weld you own shaft.

 

[DMF]

the male end should come off the pump . just buy a u joint on one end that fits the shaft and key with the female end on the other to hook to the tractor. You can buy loose parts at tractor supply and just roll pin them or weld you own shaft.

I'm not following your explanation. This is the pump I am using: http://www.princehyd.com/mobileserv...FetchLiterature?fileKey=catalogSect-ModelPT0A

It has a female attachment.

 

[M5farms]

Ok , Nevermind then , Never seen a rotary pump with that design.

 

[DMF]

It's meant to just go onto the tractor via long hoses but the pump weighs a tone and the hoses are pretty stiff; it's a hassle to wrestle it on and off so I'd like to hard mount the pump to the processor and drive it with a shaft like every other implement I own.

 

[Foodplot]

This might help:
1-3/8" 6T SHAFTING SPLINED BOTH ENDS | Splined Shafting | Shafting | Power Transmission | www.surpluscenter.com