Anybody know how to take this Curtis FEL off my Yanmar? I have no manual and can't find a website for Curtis.
I guess it should be a simple one-man operation but I just can't see how it actually comes apart.
There is a leg that is pined into the frame of the loader and it is clearly there for removal. I set it in it's holder in the center of the loader frame thinking that the bucket would sit down and the leg would act as a rear support allowing me to unpin the loader and back out. But when I sit it down on the leg, the bucket is still about 2' off the ground.
Is that leg supposed to be a balance point to allow two people, one on each side, to unpin the loader from it's attaching point and then lean it forward to back the tractor out?
Do I remove the brace that wraps around the front of the frame?
Anybody know where a web site for Curtis is?
I guess it should be a simple one-man operation but I just can't see how it actually comes apart.
There is a leg that is pined into the frame of the loader and it is clearly there for removal. I set it in it's holder in the center of the loader frame thinking that the bucket would sit down and the leg would act as a rear support allowing me to unpin the loader and back out. But when I sit it down on the leg, the bucket is still about 2' off the ground.
Is that leg supposed to be a balance point to allow two people, one on each side, to unpin the loader from it's attaching point and then lean it forward to back the tractor out?
Do I remove the brace that wraps around the front of the frame?
Anybody know where a web site for Curtis is?