Rowski
Veteran Member
- Joined
- May 18, 2000
- Messages
- 1,481
- Location
- North Central Vermont, Jay Peak Area
- Tractor
- 2004 New Holland TN70DA with 32LC loader, 2000 New Holland 2120 with Curtis cab, 7309 loader
Time to think about tip n tilt. I have one factory remote on the rear of the tractor. Having a cab would make it difficult to mount the manual spool valve in the cab. I wonder if they make electro spool valve that can be controled in the cab by switches. I'm basically looking to get three circuits total.
My thinking is that if I plumb the electro spool valve from the OE remote with quick couplers I could energize the circuit needed via a switch and use the OE lever that is in the cab to actuate the cylinders. Then when it comes time to use the backhoe I can undo the quick couplers to the spool valve and hook the back hoe up direct again.
Any thoughts, comments, suggestions?
Derek
My thinking is that if I plumb the electro spool valve from the OE remote with quick couplers I could energize the circuit needed via a switch and use the OE lever that is in the cab to actuate the cylinders. Then when it comes time to use the backhoe I can undo the quick couplers to the spool valve and hook the back hoe up direct again.
Any thoughts, comments, suggestions?
Derek